Loading

Summer highways and long trips: tyre care for Indian road trips

Most tyre failures on Indian highways come from the same mix: summer heat, a car full of people and luggage, long stretches at speed, and tyres that were a little under-inflated before the trip began. Each one heats the tyre; together they can overheat it until the tread separates or the tyre bursts. A five-minute check before you leave prevents most of it.

Heat and pressure

  • Check pressure cold: before you set off, or after the car has stood for a few hours. Tyres heat up as you drive and the pressure rises, so a reading taken mid-trip looks higher than it really is.

  • Never let air out of a hot tyre because the reading seems high. When it cools, it will be under-inflated.

  • Under-inflation is the real danger. A soft tyre flexes more, and flexing makes heat. On a hot road at highway speed, that heat builds fast.

  • Park in the shade where you can. Sun and heat age the rubber.

A full car needs more pressure

Many cars list two pressures on the door-frame sticker: one for normal driving and a higher one for a full load. With the family and luggage on board, use the full-load pressure.

  • Do not overload the car. Stay within the number of seats and the weight your owner's manual allows, including anything on a roof carrier.

  • Check the load index of your tyres matches what your car maker specifies (see our guide on reading a tyre size).

Expressways and long stretches

  • Speed and time add heat. Long runs at high speed in summer are the hardest work a tyre does. Keep to the speed limit, and to your tyres' speed rating.

  • Take a break every couple of hours. It is good for the driver, and it gives you a chance to walk round the car and look at the tyres for bulges, cuts or one that looks lower than the others.

  • Watch for debris on the road and the shoulder: broken glass, steel, tyre pieces from trucks.

Ghat and hill roads

  • Use a lower gear going downhill so the engine slows the car and the brakes do not overheat.

  • Hairpin bends scrub the front tyres. Take them slowly; it saves tread and keeps grip.

  • Check the tyres at the top if you have climbed for a long time with a full car.

The spare and the tools

  • Check the spare's pressure before every trip. A flat spare is no help.

  • Space-saver spares (a narrow temporary spare) have a top speed printed on them, often 80 km/h, and are meant only to get you to a shop.

  • Carry the jack, the wheel spanner and the locking-nut key if your wheels have one, and know where they are.

If a tyre bursts at speed

  1. Hold the steering wheel firmly with both hands and keep the car straight.

  2. Do not brake hard. Ease off the accelerator and let the car slow down on its own.

  3. When the car is under control and slow, brake gently and steer to the left shoulder.

  4. Switch on the hazard lights, get everyone out on the side away from traffic, and place the warning triangle well behind the car.

The five-minute check before you leave

  • All four tyres and the spare at the right pressure, cold, using the full-load figure if the car is full

  • Tread above 3 mm, with no cuts, cracks or bulges

  • Tyres not too old (check the DOT date)

  • No new pull or vibration on the drive to the highway

  • Jack, spanner and warning triangle in the car

New tyres before a trip?

If the check turns up worn, old or damaged tyres, post your car on OutOfBox a few days before you leave. Nearby shops send you quotes, and with mobile fitting a fitter can come to where your car is parked.